Teledyne 9110EH - Nitrogen Oxides Analyzer User Manual
Model 9110eh nitrogen oxides analyzer, Nitrogen oxides analyzer
INSTRUCTION MANUAL
NITROGEN OXIDES ANALYZER
© Teledyne Instruments
Analyical Instruments
(T
AI)
16830 Chestnut Street
City of Industry, California, CA 91748-1020,USA
USA
Toll-free Phone: 1.888.789.8168
Phone: 1.626.961.9221 or 1.626.934.1500
Fax: 1.626.961.2538 or 1.626.934.1651
Email: [email protected]
Website:
M9110EH
Rev. 0
Copyright 2003 TAI 24-September, 2003
MODEL 9110EH
NITROGEN OXIDES ANALYZER
Table of contents
Document Outline
- M200E DOCUMENTATION
- SPECIFICATIONS, APPROVALS AND WARRANTY
- GETTING STARTED
- FREQUENTLY ASKED QUESTIONS & GLOSSARY
- OPTIONAL HARDWARE AND SOFTWARE
- External Pumps (Option 10)
- Rack Mount Kits (Options 20-23)
- Carrying Strap Handle (Option 29)
- Current Loop Analog Outputs (Option 41)
- Particulate Filter Kit (Option 42A)
- Calibration Valve Options
- Scrubbers and Expendables
- Communication Options
- Sample Gas Conditioners (Options 86 & 88)
- Additional Manual (Option 70)
- Manual on CD (Option 70A)
- Extended Warranty (Options 92 & 93)
- OPERATING INSTRUCTIONS
- Overview of Operating Modes
- Sample Mode
- Calibration Mode
- Setup Mode
- Setup - Range Configuration (RNGE)
- Setup - Internal Variables (VARS)
- Setup - Diagnostics (DIAG)
- Digital Inputs and Outputs
- Setup - Communication Ports (COMM)
- Setup - Data Acquisition System (DAS)
- Remote Operation of the Analyzer
- CALIBRATION PROCEDURES
- EPA PROTOCOL CALIBRATION
- INSTRUMENT MAINTENANCE
- Maintenance Schedule
- Predictive Diagnostics
- Maintenance Procedures
- Changing the Sample Particulate Filter
- Changing the O3 Dryer Particulate Filter
- Changing the Ozone Filter Chemical
- Rebuilding the External Sample Pump
- Changing the Pump and IZS Dust Filters
- Changing the IZS Permeation Tube
- Changing the External Zero Air Scrubber
- Changing the NO2 converter
- Cleaning the Reaction Cell
- Cleaning or Changing Critical Flow Orifices
- Checking for Light Leaks
- THEORY OF OPERATION
- Measurement Principle
- Pneumatic Operation
- Electronic Operation
- Software Operation
- TROUBLESHOOTING & REPAIR
- General Troubleshooting
- Gas Flow Problems
- Calibration Problems
- Other Performance Problems
- Subsystem Checkout
- Simple Vacuum Leak and Pump Check
- Detailed Pressure Leak Check
- Performing a Sample Flow Check
- AC Power Configuration
- DC Power Supply
- I2C Bus
- Keyboard / Display Interface
- Relay Board
- Motherboard
- CPU
- RS-232 Communication
- PMT Sensor
- PMT Preamplifier Board
- High Voltage Power Supply
- Pneumatic Sensor Assembly
- NO2 Converter
- O3 Generator
- IZS Option
- Box Temperature
- PMT Temperature
- Repair Procedures
- Technical Assistance