Nortel Networks Circuit Card 311 - Manual (Page 855)

NTAK02 SDI/DCH card 855
Port 2 Port 3 SW 1-3 SW 1-4
SDI (not supported) DCH OFF OFF
SDI (not supported) DCH OFF ON
— ESDI ON ON
Note: Digital Private Network Signaling System DPNSS can replace
the DCH function in the U.K.
Two ports offer the option for DTE/DCE configuration. This option is
selected from a jumper on the card.
Table 345 "Jumper settings" (page
855) shows the jumper settings.
Table 345
Jumper settings
Port Jumper location
Strap for
DTE
Strap for
DCE
Jumper
location RS422 RS232
0 J10 C - B B - A
1 J7 J6 C - B C - B B - A B - A J9 J8 C - B C - B B - A B - A
2 J5 C - B B - A
3 J4 J3 C - B C - B B - A B - A J2 J1 C - B C - B B - A B - A
Connecting to the ports
External devices are connected to the SDI/DCH card by the following:
• the NTAK19FB four-port SDI cable. This cable does not have to be
terminated at the cross connect terminal since it is equipped with
connectors.
• the NE-A25-B cable. Terminate the NE-A25-B cable at the cross
connect terminal. Tables
Table 346 "NTAK02 pinouts - Port 0 at the
cross-connect terminal" (page 855) through Table 349 "NTAK02
connections at the cross-connect terminal - Port 3" (page 857) give
the pinouts for the SDI/DCH card.
Table 346
NTAK02 pinouts - Port 0 at the cross-connect terminal
RS232
Cable
Signal
Designations
I=Input O=Output
Pair Color DTE DCE DTE DCE
1T
1R
W-BL
BL-W 0
DTR
0
DCD
—
O
—
I
Nortel Communication Server 1000
Circuit Card Reference
NN43001-311 01.04 Standard
Release 5.0 23 May 2008
Copyright © 2003-2008, Nortel Networks
.