Nortel Networks Circuit Card 311 - Manual (Page 493)

Configuring the Data Access card 493
Printing the card parameters (LD 20)
By responding R232, R422, or DAC to the TYPE prompt in LD 20, you can
print out the configured parameters for each port, or the entire DAC. This is
useful to determine if any parameters have been altered during keyboard or
Hayes dialing modify procedures.
LD 20 - Print DAC parameters.
Prompt Response Description
REQ: PRT
LTN
LUU Print data, TN, or unit information for the unit specified
TYPE: R232
R422
DAC Print information for the RS-232-C, RS-422 ports, or the
whole DAC
TN l s c u Print information for this TN, where l = loop, s = shelf, c =
card, u = unit. Uploaded parameters can only be printed
when a specific TN is listed.
The operation parameter printout for an RS-232 or RS-422 port is similar
to the following, depending on the configuration.
Table 194
Print out example
DBASE
R-232 or R-422
UPLOAD
R-232 or R-422
PAR SPAC SPAC
DTR ON ON
HOT OFF OFF
AUT ON O
AUTB ON ON
BAUD 9600 4800
DCD OFF OFF
PRM KBD ON KBD ON
DEM DCE DCE
DLNG FRN FRN
KBD ON ON
Note: The Upload parameters are printed only when a single TN is specified.
Nortel Communication Server 1000
Circuit Card Reference
NN43001-311 01.04 Standard
Release 5.0 23 May 2008
Copyright © 2003-2008, Nortel Networks
.