Nortel Networks Circuit Card 311 - Manual (Page 563)

Configuration 563
Figure 139
Analog message waiting line card - typical cross connection example
Configuration
This section outlines the procedures for configuring the switches and
jumpers on the NT8D09 Analog Message Waiting Line Card and configuring
the system software to properly recognize the card.
Figure 140 "Analog
message waiting line card - jumper block and switch locations" (page
565)
shows where the switches and jumper blocks are located on this board.
Jumper and switch settings
The NT8D09 Analog Message Waiting Line Card has no user-configurable
jumpers or switches. The card derives its address from its position in the
backplane and reports that information back to the Meridian 1 CPU through
the LAN Link interface.
Nortel Communication Server 1000
Circuit Card Reference
NN43001-311 01.04 Standard
Release 5.0 23 May 2008
Copyright © 2003-2008, Nortel Networks
.