Nortel Networks Circuit Card 311 User Manual
Page 383
383
NT6D71 UILC line card
Contents
This section contains information on the following topics:
"Physical description" (page 384)
"Functional description" (page 384)
Introduction
The NT6D71 U Interface Line card (UILC) supports the OSI physical layer
(Layer 1) protocol. The UILC is an ANSI-defined standard interface. The
UILC provides eight two-wire full-duplex (not polarity sensitive) U interfaces
to connect ISDN BRI-compatible terminals over Digital Subscriber Loops
(DSL) to the CS 1000E, CS 1000M, and Meridian 1. A description of the
ISDN BRI feature is contained in ISDN Basic Rate Interface: Installation
and Configuration (NN43001-318).
You can install this card in any IPE slot.
Note: A maximum of four UILCs are supported in an Media Gateway
and Media Gateway Expansion.
The NT6D71 U Interface Line Card (UILC) supports the OSI physical layer
(Layer 1) protocol. The UILC is an ANSI defined standard interface. The
UILC provides eight two-wire full duplex (not polarity sensitive) U interfaces
that are used to connect ISDN BRI compatible terminals over DSLs to the
Meridian 1. A description of the ISDN BRI feature is contained in ISDN
Basic Rate Interface: Maintenance (NN43001-718).
The NT6D71 U Interface Line Card (UILC) supports the OSI physical layer
(Layer 1) protocol. The UILC is an ANSI-defined standard interface. The
UILC provides eight two-wire full-duplex (not polarity sensitive) U interfaces
Nortel Communication Server 1000
Circuit Card Reference
NN43001-311
01.04
Standard
Release 5.0
23 May 2008
Copyright © 2003-2008, Nortel Networks
.