Nortel Networks Circuit Card 311 - Manual (Page 527)

Configuration 527
Table 207
NT8D02 Digital Line Card - backplane pinouts
Backplane
Pinout*
Lead
Designations
Backplane
Pinout*
Lead
Designations
12A Line 0, Ring 12B Line 0, Tip
13A Line 1, Ring 13B Line 1, Tip
14A Line 2, Ring 14B Line 2, Tip
15A Line 3, Ring 15B Line 3, Tip
16A Line 4, Ring 16B Line 4, Tip
17A Line 5, Ring 17B Line 5, Tip
18A Line 6, Ring 18B Line 6, Tip
19A Line 7, Ring 19B Line 7, Tip
62A Line 8, Ring 62B Line 8, Tip
63A Line 9, Ring 63B Line 9, Tip
64A Line 10, Ring 64B Line 10, Tip
65A Line 11, Ring 65B Line 11, Tip
66A Line 12, Ring 66B Line 12, Tip
67A Line 13, Ring 67B Line 13, Tip
68A Line 14, Ring 68B Line 14, Tip
69A Line 15, Ring 69B Line 15, Tip
*These pinouts apply to both the NT8D37 and NT8D11 backplanes
Configuration
This section outlines the procedures for configuring the switches and
jumpers on the NT8D02 Digital Line card and configuring the system
software to properly recognize the card.
Figure 131 "Digital line card -
jumper block and switch locations" (page 529) shows where the switches
and jumper blocks are located on this board.
This section outlines the procedures for configuring the switches and
jumpers on the NT8D02 Digital Line Card and configuring the system
software to properly recognize the card.
Figure 132 "Digital line card -
jumper block and switch locations" (page 530) shows where the switches
and jumper blocks are located on this board.
This section outlines the procedures for configuring the switches and
jumpers on the NT8D02 Digital Line Card and configuring the system
software to properly recognize the card.
"NT8D02 Digital Line Card - jumper
block and switch locations" (page 531) shows where the switches and
jumper blocks are located on this board.
Nortel Communication Server 1000
Circuit Card Reference
NN43001-311 01.04 Standard
Release 5.0 23 May 2008
Copyright © 2003-2008, Nortel Networks
.