Table 316 sdi paddle board address switch settings, Configuring the sdi paddle board – Nortel Networks Circuit Card 311 User Manual
Page 815
Configuring the SDI paddle board
815
Configuring the SDI paddle board
Configuring the SDI paddle board to work in a Meridian 1 system consists of
setting these option switches for each serial port:
•
Port address
•
Baud rate
•
DTE/DCE/Fiber mode
The SDI paddle board has seven option switches, SW 2–8.
paddle board option switch locations" (page 817)
identifies the location of
option switches on the SDI paddle board. Instructions for setting these
switches are in the section that follows.
Once the board has been installed, the system software must be configured
to recognize it. Instructions for doing this are found in "
Option switch settings
Address
Address select switch SW4 and logic on the card always address the two
UARTs using a pair of addresses: 0 and 1, 2 and 3 through 15 and 16. The
settings for this switch are shown in
Table 316 "SDI paddle board address
Table 316
SDI paddle board address switch settings
Address
Switch SW4
Port 1
Port 2
1
2
3
4
0
1
off
on
on
on
2
3
off
on
on
off
4
5
off
on
off
on
6
7
off
on
off
off
8
9
off
off
on
on
10
11
off
off
on
off
12
13
off
off
off
on
14
15
off
off
off
off
Baud rate
Switches SW2 and SW3 determine the baud rate for each individual port.
The settings for these switches are shown in
baud rate switch settings" (page 816)
Nortel Communication Server 1000
Circuit Card Reference
NN43001-311
01.04
Standard
Release 5.0
23 May 2008
Copyright © 2003-2008, Nortel Networks
.