Nortel Networks Circuit Card 311 - Manual (Page 545)

Functional description 545
• 20-Hz ringing signal connection and automatic disconnection when the
station goes off-hook
• synchronization for connecting and disconnecting the ringing signal
to zero crossing of ringing voltage
• loopback of SSD messages and pulse code modulation (PCM) signals
for diagnostic purposes
• correct initialization of all features at power-up
• direct reporting of digit dialed (500-type telephones) by collecting dial
pulses
• connection of -150 V DC at 1 Hz to activate message waiting lamps
• lamp status detection
• disabling and enabling of selected units for maintenance
The NT8D09 Analog Message Waiting Line Card contains a microprocessor
that provides the following functions:
• self-identification
• self-test
• control of card operation
• status report to the controller
• maintenance diagnostics
The NT8D09 Analog Message Waiting Line Card also provides the following:
• 600 ohms balanced terminating impedance
• analog-to-digital and digital-to-analog conversion of transmission and
reception signals for 16 audio phone lines
• transmission and reception of Scan and Signaling Device (SSD)
signaling messages over a DS-30X signaling channel in A10 format
• on-hook/off-hook status and switchhook flash detection
• 20 Hz ringing signal connection and automatic disconnection when the
station goes off-hook
• synchronization for connecting and disconnecting the ringing signal
to zero crossing of ringing voltage
• loopback of SSD messages and Pulse Code Modulation (PCM) signals
for diagnostic purposes
• correct initialization of all features at power-up
• direct reporting of digit dialed (500-type telephones) by collecting dial
pulses
Nortel Communication Server 1000
Circuit Card Reference
NN43001-311 01.04 Standard
Release 5.0 23 May 2008
Copyright © 2003-2008, Nortel Networks
.