Nortel Networks Circuit Card 311 - Manual (Page 304)

304 NT5D33 and NT5D34 Lineside E1 Interface cards
Idle SEND – This is the value that the LEI sends (acting as the CO or
PSTN) when the circuit is in the idle state. This value is required.
Idle RECEIVE – This is the value that the LEI expects to see from the CPE
when it is in the idle state. This value is required.
Blocking RECEIVE – This is the value that the LEI expects to see from the
CPE when the customer equipment is in the blocking or fault state and is
unable to accept new calls. Set this value to N if this state is not needed. If
this value is not set to N, then dip switch #2 position 6 determines whether
off-hook or on-hook is sent to the M1/SL100 when this state is entered. See
Table 118 "LEI card - E1 Switch 2 (S2) dip switch settings" (page 279) .
Figure 70
Set Mode (S M): Table screen
Nortel Communication Server 1000
Circuit Card Reference
NN43001-311 01.04 Standard
Release 5.0 23 May 2008
Copyright © 2003-2008, Nortel Networks
.