Nortel Networks Circuit Card 311 - Manual (Page 428)

428 NT7D16 Data Access card
Service changeable downloadable parameters (LD 11)
Operation
mode
Modem/
Gateway/
Host/KBD
Forced
DTR*
Hotline
Type of device
to be connected
Group selection
DEM PRM DTR HOT
6 (DTE) ON
"KBD On"
(No RI) ON
Forced OFF
Not
Hotline Gateway inbound
and outbound
(DTR is on in idle
state)
MSB by DCD
7 (DTE) ON
"KBD On"
(No RI) ON
Forced ON
Hotline Gateway inbound
only (Hotline by
DCD:
ON for Hotline
OFF for VLL)
(DTR is ON in idle
state)
8 (DCE) OFF
"Host On"
(prompts off) OFF
Not
Forced OFF
Not
Hotline Outbound to Host
(similar to Multi
Channel Data
System (MCDS))
Prompt PBDO =
OFF/ON Modes 8 and 9
are for RS422
Host connectivity
9 (DCE) OFF
"Host On"
(prompts off) OFF
Not
Forced On
Hotline Host Hotline by
DTR
10 (DCE) OFF
"Host On"
(prompts off) ON
Forced OFF
Not
Hotline Host similar to
MCDS but does
not require DTR
to be ON Modes 8, 9,
10, and 11 are
for RS232 Host
connectivity
11 (DCE) OFF
"Host On"
(prompts off) ON
Forced On
Hotline Continuous
Hotline mode
when DTR is ON
(VLL)
12 (DCE) ON
"KBD On"
(prompts on) OFF
Not
Forced OFF
Not
Hotline Terminal similar
to Asynchronou
s/Synchronous
Interface Module
(ASIM) when set
to Not Forced
DTR and Not
Hotline Prompt
PBDO = OFF/ON Modes 12 and
13 are for
RS422 Terminal
connectivity
* Not prompted for Type = R422. Defaults for Type = R422: DEM = DCE and DTR = OFF.
Nortel Communication Server 1000
Circuit Card Reference
NN43001-311 01.04 Standard
Release 5.0 23 May 2008
Copyright © 2003-2008, Nortel Networks
.