FUJITSU F2MC-8L F202RA - Manual (Page 74)

58
CHAPTER 3 CPU
3.6.4 Clock Mode
The clock speed is switched by selecting one of four frequency-divided source clocks
(gears).
■ Operations in Each Clock Mode
Each clock mode allows transition to a corresponding standby (sleep/stop) mode. For details of standby
mode, see Section "3.7 Standby Mode (Low-Power Consumption Mode) ".
■ Gears (Clock Speed Switching Function)
Writing one of 00
B
to 11
B
into the clock speed selection bits (SYCC: CS1 and CS0) in the system clock
control register selects one of four clock speeds.
The CPU and peripheral circuits operate using the clock speed selected. However, the gear does not affect
the time-base timer.
Power consumption can be reduced by lowering the clock speed.
Table 3.6-2 Operations in Each Clock Mode
Clock speed
Standby
mode
Clock
Operating clock in each block
Cause that cancels
standby mode
(excepting reset)
SYCC register
(SYCC: CS1
and CS0)
CPU
time-base
timer
Peripheral
function
(1, 1)
High
speed
Low
speed
RUN
Generated
F
CH
/4
F
CH
/2 F
CH
/4
Interrupt request
Sleep
Stopped
Stop Stopped Stopped Stopped External interrupt
(1, 0)
RUN
Generated
F
CH
/8
F
CH
/2 F
CH
/8
Interrupt request
Sleep
Stopped
Stop Stopped Stopped Stopped External interrupt
(0, 1)
RUN
Generated
F
CH
/16
F
CH
/2 F
CH
/16
Interrupt request
Sleep
Stopped
Stop Stopped Stopped Stopped External interrupt
(0, 0)
RUN
Generated
F
CH
/64
F
CH
/2 F
CH
/64
Interrupt request
Sleep
Stopped
Stop Stopped Stopped Stopped External interrupt