FUJITSU F2MC-8L F202RA - Manual (Page 120)

104
CHAPTER 4 I/O PORTS
●
Port 6 pull-up setting register (PUL6)
The bits of the pull-up setting register correspond to the pins of port 6 in one-to-one correspondence.
When the pull-up resistor is selected by using the pull-up setting register, the pin will be at "H" level
(pull-up state) instead of Hi-Z during stop (SPL = 1). During a reset, however, the pull-up is invalid and
the pin remains at Hi-Z.
Figure 4.6-2 shows the pull-up resistor settings assigned to the values of the bits of the port 6 pull-up
setting register.
Figure 4.6-2 Pull-up Resistor Settings (PUL6)
PUL61 PUL60
0
1
bit7 bit6 bit5 bit4 bit3 bit2 bit1 bit0
0062
H - - - - - PUL61 PUL60 ------00
B
- - - - - R/W R/W
R/W
Address Initial value
P61 pull-up OFF P60 pull-up OFF
P61 pull-up ON P60 pull-up ON
: Readable/Writable
: Initial value
-
-