Avago Technologies LSI53C895A - Manual (Page 118)

4-10 Registers
Registers: 0x18–0x1B
Base Address Register Two (SCRIPTS RAM)
Read/Write
BAR2 Base Address Register Two [31:0]
This base register is used to map the SCRIPTS RAM into
memory space. The default value of this register is
0x00000000. The LSI53C895A points to 8192 bytes of
address space with this register. This register has
bits [12:0] hardwired to 0b0000000000000. For detailed
information on the operation of this register, refer to the
PCI 2.2 specification.
Registers: 0x1C–0x27
Not Supported
Registers: 0x28–0x2B
Reserved
Registers: 0x2C–0x2D
Subsystem Vendor ID
Read Only
SVID Subsystem Vendor ID [15:0]
This 16-bit register is used to uniquely identify the vendor
manufacturing the add-in board or subsystem where this
PCI device resides. It provides a mechanism for an
add-in card vendor to distinguish its cards from another
31 0
BAR2
0 0 0 0 0 0 0 0 0 0 0 0 0 0 0 0 0 0 0 0 0 0 0 0 0 0 0 0 0 0 0 0
15 0
SVID
If MAD[7] HIGH Default
0 0 0 1 0 0 0 0 0 0 0 0 0 0 0 0
If MAD[7] LOW See Description Default
x x x x x x x x x x x x x x x x