Yaskawa Z1000U - Manual (Page 63)

3.5 Terminal Cover
Follow the procedure below to remove the terminal cover for wiring and to reattach the terminal cover after wiring is complete.
u Models 2o0028 to 2o0130 and 4o0011 to 4o0124
n Removing the Terminal Cover
1.
Loosen the terminal cover screw.
Figure 3.9 Removing the Terminal Cover
2.
Push in on the tab located on the bottom of the terminal cover and gently pull forward to remove the terminal cover.
Figure 3.10 Removing the Terminal Cover
n Reattaching the Terminal Cover
Power lines and signal wiring should pass through the opening provided. Refer to Wiring the Main Circuit Terminal on
page 81 and Wiring the Control Circuit Terminal on page 85 for details on wiring.
Reattach the terminal cover after completing the wiring to the drive and other devices.
3.5 Terminal Cover
YASKAWA ELECTRIC TOEP C710636 10B Z1000U HVAC MATRIX Drive User Manual 63
3
Electrical Installation