Yaskawa Z1000U HVAC MATRIX Drive Instruction Manuals and User Guides
We have 1 Instruction Manual and User Guide for Z1000U HVAC MATRIX Drive Yaskawa
Manuals 
| Recognized languages: | English |
|---|---|
| Pages: | 378 |
| Size: | 26.68 MB |
Show table of contents
Document Outline
- Preface & General Safety
- Receiving
- Mechanical Installation
- Electrical Installation
- Start-Up Programming & Operation
- Section Safety
- Using the HOA Keypad
- The Drive, Programming, and Clock Adjustment Modes
- Start-Up Flowcharts
- Powering Up the Drive
- Application Selection
- HVAC Application Parameters
- Setting 1: Fan Application
- Setting 2: Fan with PI Control Application
- Setting 3: Return Fan with PI Control Application
- Setting 4: Cooling Tower Fan Application
- Setting 5: Cooling Tower Fan with PI Control Application
- Setting 6: Pump (Secondary) Application
- Setting 7: Pump with PI Control Application
- Basic Drive Setup Adjustments
- Auto-Tuning
- No-Load Operation Test Run
- Test Run with Load Connected
- Verifying Parameter Settings and Backing Up Changes
- Advanced Drive Setup Adjustments
- Troubleshooting
- Section Safety
- Motor Performance Fine-Tuning
- Drive Alarms, Faults, and Errors
- Fault Detection
- Alarm Detection
- Operator Programming Errors
- Auto-Tuning Fault Detection
- Copy Function Related Displays
- Diagnosing and Resetting Faults
- Troubleshooting without Fault Display
- Common Problems
- Cannot Change Parameter Settings
- Motor Does Not Rotate Properly after Pressing AUTO Button orafter Entering External Run Command
- Motor is Too Hot
- Drive Does Not Allow Selection of the Desired Auto-Tuning Mode
- oPE02 Error Occurs When Lowering the Motor Rated Current Setting
- Motor Stalls during Acceleration or Acceleration Time is TooLong
- Drive Frequency Reference Differs from the Controller FrequencyReference Command
- Excessive Motor Oscillation and Erratic Rotation
- Deceleration Takes Longer than Expected
- Noise From Drive or Motor Cables When the Drive is PoweredOn
- Ground Fault Circuit Interrupter (GFCI) Trips During Run
- Connected Machinery Vibrates When Motor Rotates
- PID Output Fault
- Motor Rotates after the Drive Output is Shut Off (Motor RotatesDuring DC Injection Braking)
- Output Frequency is Not as High as Frequency Reference
- Sound from Motor
- Unstable Motor Speed when Using PM
- Motor Does Not Restart after Power Loss
- The Safety Controller Does Not Recognize Safe Disable MonitorOutput Signals (Terminals DM+ and DM-)
- Peripheral Devices & Options
- Section Safety
- Drive Options and Peripheral Devices
- Connecting Peripheral Devices
- Option Installation
- Installing Peripheral Devices
- Installing a Molded Case Circuit Breaker(MCCB) or Ground Fault Circuit Interrupter (GFCI)
- Installing a Magnetic Contactor at the Power Supply Side
- Connecting a Surge Absorber
- Reducing Noise
- Attachment for External Heatsink Mounting
- Internal EMC Filter Model Installation
- Installing a MotorThermal Overload (oL) Relay on the Drive Output
- Specifications
- Parameter List
- BACnet Communications
- BACnet Configuration
- Communication Specifications
- Connecting to a Network
- BACnet Setup Parameters
- Drive Operations by BACnet
- Communications Timing
- BACnet Objects Supported
- Accessing Drive Parameters and the Enter Command
- Communication Errors
- Self-Diagnostics
- BACnet Protocol Implementation Conformance Statement
- Standards Compliance
- Quick Reference Sheet