Grass Valley Kayenne K-Frame v.7.0 User Manual
Page 93
KAYENNE K-FRAME — User Manual
93
Splitting a Key
A split key can be created three different ways:
•
Configure a source in the Eng Setup/Source Destination menu that
uses different video for cut than for fill. That split key will initially be
used whenever that engineering source is selected. See the K-Frame
Installation and Service Manual for more information.
•
Setup a key patch (an implicit split key). This split key is used whenever
that logical source is selected, and adds operational flexibility. See Patch
a Key Input from One Source to a Different Source Using Patch Key
for more information.
•
Setup an explicit split key using the Source Ops menu. This split key is
used only at the time is has been set. Selecting a different source, then
returning to that formerly split source removes the split key.
To create an explicit split key:
1.
Touch Source Ops, MEs (
).
Figure 48. Split Key—Source Ops, MEs Menu
2.
Touch an ME button (left).
3.
Touch the Cut signal data pad for the Keyer you wish to split
(highlights blue).