Grass Valley Kayenne K-Frame v.7.0 - Manual (Page 207)

KAYENNE K-FRAME — User Manual 207
Figure 115. DCM—Cue Links
Hold down a lettered button ( A - F) and press the Link Cue button (high tallies
blue), the Cue Device Selection menu is displayed ( Figure 115 ). Press the
device buttons to add (or remove) devices as part of the cue then press the
ENT (or Link Cue ) button. All device buttons added to the cue will tally blue.
Pressing the CLR button clears all devices from the cue.
Note Both loop cue status and link status are always learned into the cue; if the
Loop button is high tally, then a loop is learned and if Link Cue button is high
tally blue, then the multiple devices are linked into the cue.
When recalled, a clip will load and cue for each device linked into the
Q-MEM register. (There is one Play command per register so if learned as
part of a Cue register, all devices will play when the register is recalled.)
Learning Only Device Associations into a Register
Cues can be used to associate devices to lettered buttons only, without
learning clip and mark information. So on recall, the devices are assigned
to the lettered buttons but nothing is done to the current status of the
devices.
The Cue Device Selection menu is used to configure these associa-
tions.
To associate a devices to lettered buttons only:
1. Hold down a lettered button, and press the Link Cue button. Both the
letter button and the button for the device high tally.
2. Turn on any other letter buttons, but turn off the device buttons. If the
letter button is on and the device button is off, then only the device
association will be learned into the register.
Go To
TC TC
Mark
In In
Link Link
Cue
Cue
Set Set
In
In
Mark
Out Out
Set Set
Out
Out
Cue Cue
Load
Loop Loop Var
Sh Shutl
A B C D E F
CLR
ENT
K2-1 K2-4 K2-3 K2-2
CS-1 CS-4 CS-3 CS-2
IS 1 IS 4 IS-3 IS 2
IS 5 IS 6
8623267_34
G V / B r i g h t S t a r
I Ø Ø : Ø Ø : Ø Ø : 2 2 O U Ø Ø : Ø Ø : Ø 7 : 2 4
D Ø Ø : Ø Ø : Ø 7 : Ø 2 T C Ø Ø : Ø Ø : Ø Ø : Ø Ø
C S - 1 1 2 3 4 5 M I S C 4