Grass Valley Kayenne K-Frame v.7.0 - Manual (Page 40)

40 KAYENNE K-FRAME — User Manual
Section 3 — Setting Suite Preferences
to two Logical IDs, and one of these Logical sources can be given a Source
Rule that can be cut on Key 5, and the other be given a Source Rule that cuts
on Key 6. Selecting these different versions of that same source would auto-
matically apply or clear the keys, as needed.
Figure 18. Source Patch Menu
Engineering Names, Eng IDs, and Logical IDs
Engineering names are intended to identify a source as it applies to a spe-
cific facility. In a truck, for example, cameras may be hard wired to the pro-
duction switcher and might be given Engineering names 1, 2, and 3. Names
like Patch 14 or Rtr 5 may be used for inputs that are patched or routed.
Engineering names are entered in the Eng Setup Source Definition menu,
as described above. Engineering source IDs are numeric only, and are avail-
able on data pads and scroll knobs for quick selection. The GV Switcher
system also has logical IDs, that can be used for source patching, as
explained later.
Alternative Source Names
Alternative names can be assigned to sources for the convenience of pro-
duction personnel. For example, you may give the cameras menu names
that include the operator (C1 Bob, C2 Phil, and C3 Bill), but remove the