Gangs, Q-mem – Grass Valley Kayenne K-Frame v.7.0 User Manual
Page 204
204
KAYENNE K-FRAME — User Manual
Section 6 — Device Control
Gangs
When devices are ganged, motion control commands are applied to all the
devices in the gang. Play, Stop, Cue to Mark-In, etc. are performed simulta-
neously for all devices in the gang. Loading clips, which is not motion con-
trol, is not included in a gang. To load more than one device at the same
time, use a Q-MEM linked cue (see Learning Additional Devices
).
Ganging Devices Associated with Lettered Buttons
To gang devices associated with the
A - F
lettered buttons on the DCM, press
and hold down the letter buttons and press the
Gang
button (the ganged
buttons tally green). For example, hold down
A
and
B
buttons (or any com-
binations of
A - F
with devices associated) and press the
Gang
button on the
DCM. The devices associated with
A
and
B
are ganged. Pressing the
CLR
button during device gang selection clears all devices from the gang.
Ganging Additional Devices
Hold down a single lettered button (
A - F)
and press the
Gang
button (Gang
Device Selection appears on the status display). A menu of devices is dis-
played that you can add (or remove) in association with the lettered button.
You can page through and press the device buttons to make your selections.
Once you’ve made your selections as part of the gang, press the
ENT
(or
Gang
) button to gang the devices.
The DCM supports multiple gangs, so there may be a gang associated with
the device on the
A
button, and another gang on the device associated with
the
B
button, and so on.
When the Gang button is high-tallied green, then there is an active gang
associated with the selected letter button. To temporarily disable the gang,
press the
Gang
button; it will low tally green, then make an adjustment.
Pressing
Gang
again, will re-enable the gang. For example, this can be used
where one device is video and the other key. By pressing the
Gang
button
you can turn off the gang temporarily, jog the key channel to more precisely
align it with the fill, and then re-enable the gang.
Panel Gangs
The “Panel Gang” (Local Aux Bus gang) and the gang on the ‘
F
’ button are
the same when the
SDEL
button is selected. Gang selections made from the
DCM in this way also affect gang selections made in the Local Aux Bus
Module and vice versa.
Q-MEM
Q-MEM can be used to assign a device to a letter button on the DCM
(
), load a named clip on that device and cue to its mark-in point,