Grass Valley Kayenne K-Frame v.7.0 - Manual (Page 196)

196 KAYENNE K-FRAME — User Manual
Section 6 — Device Control
Multi-Function Module
The Multi-Function Module supports Single and Multiple Device Control.
In Single Device Control mode, you have full VTR control of an Event List
right on the Control Panel. In Multiple Device Control mode, you can select
and control up to eight devices at a time from the Control Panel, with Stop,
Cue, and Play for each (including gangs).
Single
To place the Multi-Function Module in Single Device Control mode, press
the
Devs button from the HOME position, then press the Sngl button located
below and right of the joystick ( Figure 110 ) on the Multi-Function Module.
Follow Mode
When in Follow mode, the default, the Multi-Function Module tracks the
right-most Device Control group on the System Bar (see System Bar
on
page 193 ). The current device is shown in the function button status display
just below the Joystick, on the right side of the Multi-Function Module.
‘Device Follow’ is displayed in the LED to the right of the top soft knob
(
Figure 110 ).
Figure 110. Multi-Function Module, Single Device Control Mode, Follow Mode
Device Selection
Device Selection is performed by turning the top soft knob. Turning this
knob in Device Control mode scrolls through the associated devices (seen
in the status display). Turning the soft knob immediately delegates the
Multi-Function Module to the newly selected device (
Figure 111 ).
Wipe ipe
1
Key Key
5
Key Key
3
Key Key
1
Wipe ipe
2
Key Key
6
Key Key
4
Key Key
2
01:0 0:20 :00
Clip+1
- - -
K2-3-3
Adel Last
ADV CUE
REW
APLY
BEGN FF END JOG+ JOG-STOP
HOME
8623267_18
DEVICE
FOLLOW
Cur Clip
Sprt-Fill
Clip+2
- - -
Clip+3
- - -
GOTO
PLAY
PREV NEXT Sngl
MULT