Grass Valley Kayenne K-Frame v.7.0 - Manual (Page 230)

230 KAYENNE K-FRAME — User Manual
Section 6 — Device Control
Figure 125. Control Menu
3. Press the LRN button in the Control Panel Master E-MEM Module, then
press the Page, Bank, and Register keypad number of the desired
register. This will save the current R-MEM setting in the menu to the
header area of that E-MEM effect register and the first keyframe of the
new effect will be created. The corresponding R-MEM register in the
menu will also be updated.
Changing R-MEM on an Existing E-MEM Register
1. On the Master E-MEM Module, recall the E-MEM register you wish to
change.
2. On the Master E-MEM Module, select the Enable button to which
R-MEM has been assigned.
3. Setup the desired R-MEM state.
a. Go to the R-MEM Router, Control menu (accessed via Router , Control )
and select the router source to be used with each switcher source.
b. Go to the R-MEM menu (touch the R-MEM category selection button)
and enable the desired switcher sources. Select Auto Recal l if you
want the ability to recall R-MEM settings for only the selected
switcher sources.