Grass Valley Kayenne K-Frame v.7.0 - Manual (Page 302)

302 KAYENNE K-FRAME — User Manual
Section 8 — Advanced Operations
transition, using the transition rules to determine the exact behavior of the
transitioning keys.
1. Go to the keyframe in the effect where you wish the key transition(s) to
begin.
2. Select the Key 1-6 next transition button(s) for the keyer element(s)
involved. Selected keys that are on will transition off, and keys that are
off will transition on.
3. Select the type of transition ( Mix , Wipe 1 , or Wipe 2 ).
4. Press Modify to change the keyframe to the values set above.
5. Change the on/off state of the keys you wish to transition.
6. If you are transitioning in a new key, select the source on that key bus.
If you are transitioning out a key, do NOT change the source selected
on the key bus for that keyer (this prevents an unwanted cut).
7. Press Insert After to add this keyframe to the effect.
8. Repeat the steps above for any additional keyer transitions.
9. Rewind and run the effect to check its operation. The transition(s) will
occur as programmed.
Changing the Length of an E-MEM Transition
Change the keyframe duration of the first keyframe involved in that tran-
sition.
1. Go to the first keyframe for that transition.
2. Press KF Duration and then enter a value in •
format on the keypad.
3. Press Modify KF .
About Preventing Elements from Transitioning in E-MEMs
To ensure a transition for an element does not occur, simply make sure the
next transition button for that element is off in the keyframe by selecting
another element’s button.
To ensure no transition occurs at all at a keyframe (any changes will be
cuts), you can select only the next transition button for a keyer and make
sure its state does not change in the next keyframe. A change of state in a
keyer is required for a transition to occur when the effect runs.