Grass Valley Kayenne K-Frame v.7.0 User Manual
Page 255
KAYENNE K-FRAME — User Manual
255
Control Panel Overview
Note
To delegate one row, hold down the Macro button and press a bus delegation
button or hold down the bus delegation row button and press the Macro
button.
•
Key Split
button—Creates a split key when a source is selected for the fill
signal, the
Key Split
button is held down, and a source is selected on a
row delegated to the key bus.
•
Far
button—The Far modifier is used for DPM rotation transitions.
During DPM operations, the side that is seen by the user is defined as
the ‘near side’. To set the far side for the current delegation of a bus,
press and hold the
Far
button (and shift button if necessary) and make
a source selection for that side.
•
Aux
select button—Delegates Rows 1 and 2 of a Source Select Module to
Aux bus control.
•
Router
select button—Delegates Rows 1 and 2 of a Source Select Module
to Router selection.
•
Rules Hold
button—When pressed (toggle), Source Rules will not be
applied to the ME delegated to that Source Select Module.
•
E-MEM
select button—Delegates rows 1 and 2 of a Source Select Module
to E-MEMs.
Note
To delegate one row, hold down the E-MEM button and press a bus delega-
tion button or hold down the bus delegation row button and press the E-MEM
button.
•
Pri
partition select button—Delegates all four rows of a Source Select
Module to the primary partition (Rows 1 and 2 are delegated to the last
delegation when
Pri
was used, Row 3 is delegated to the A bus and Row
4 is delegated to the B bus).
•
Sec
partition select button—Delegates all four rows of a Source Select
Module to the secondary partition (Rows 1 and 2 are delegated to the
last delegation when
Sec
was used, Row 3 is delegated to the U1 bus
and Row 4 is delegated to the U2 bus).
•
Pressing the
Pri
and
Sec
buttons together causes both buttons to high
tally. Both partitions are controlled but only tallies for the Primary
partition will be seen on the Source and Local E-MEM modules.
Note
Pressing the Pri or Sec buttons delegates the Transition and Local E-MEM
Modules in addition to the Source Select Module and modifies what wipe
generators can be selected on the Matte and Wipe delegations of the Multi-
Function Module.
•
ME delegation indicator—Located between the
Sec
and
Rules Hold
but-
tons, displays the current delegation of the panel row to the logical ME
(ME-1, ME-2, PGM, etc.).