Grass Valley Kayenne K-Frame v.7.0 - Manual (Page 197)

KAYENNE K-FRAME — User Manual 197
Pushing down the top soft knob returns the Multi-Function Module to the
Follow mode.
Figure 111. Multi-Function Module, Single Device Control, Selection Mode
Current Clip
Current clip selection is made by turning the soft knob, second from the top
(
Figure 111 ). The current clip in the Event List is shown in the status display
LED just right of the soft knob. Pushing down the soft knob loads the
selected clip.
Event List Editing
Turning any of the lower three soft knobs in Single Device Control mode on
the Multi-Function Module changes the clip name in the adjacent OLED
and three buttons are added in the main function area;
INS , MOD , and DEL
( Figure 112 ).
Note After the INS, MOD, or DEL button is pushed, the editing buttons turn off.
INS button—Causes the new clip name from the clip list, in the Current
Folder in the Clip Browser (see E-MEM Control of External Devices ), to be
inserted into the Event List. Clips can be inserted into the Event List in the
1st, 2nd, or 3rd position in the list using the bottom three soft knobs. All
other clip names will be pushed down one.
Note Only one of the three bottom soft knobs are active at a time in Device
Control mode.
Wipe ipe
1
Key Key
5
Key Key
3
Key Key
1
Wipe ipe
2
Key Key
6
Key Key
4
Key Key
2
01:0 0:20 :00
Clip+1
- - -
Sprt-Fill
Adel Last
ADV CUE
REW
APLY
BEGN FF END JOG+ JOG-STOP
HOME
8623267_19
DEVICE
K2-3-3
Cur Clip
Sprt-Fill
Clip+2
- - -
Clip+3
- - -
GOTO
PLAY PREV NEXT Sngl
MULT