Grass Valley Kayenne K-Frame v.7.0 - Manual (Page 217)

KAYENNE K-FRAME — User Manual 217
Operating an External Device from the GV Switcher
5. Touch the Play button on the Timeline Events menu.
6. Set up your control panel to the desired state, including selecting the
DDR on the PGM-PST A bus.
7. Press or >Insert to add the keyframe information to the E-MEM
register.
8. Go to a point later in your effect giving sufficient time for the desired
material in the clip to play. For example, for a 20 second clip that started
at three seconds, press
GoTm , 23 , • , ENT .
9. Touch the Clear Events button in the Events pane to deselect the old
commands.
10. Touch the Stop button.
11. Set up your control panel to the desired state, including selecting an
alternate source on the PGM-PST A bus.
12. Press or >Insert to add the keyframe information to the E-MEM
register.
13. Touch the Clear Events button in the Events pane to deselect the
commands.
14. Recall and run the register. The clip will load and cue, be taken on-air,
play automatically, be taken off-air and then stop.
Playing a Video and Key Pair of Sources in Sync from an External
Device
1. Besides EXT DEV (or whichever button your machine control device has
been associated with), make sure PGM PST level is also enabled in the
Master E-MEM Module.
2. In the Timeline Events menu, delegate the device to be used for the
video signal, and select
Load and Cue events for it. Do not add these
events to a keyframe yet.
3. Delegate the device to be used for the key signal, and select Load and Cue
events for it.
4. Set up the Control Panel so PGM PST Key 1 is not on-air and the DDR
source is not selected on the PGM PST A bus.
5. Add this to the first keyframe of the effect by pressing or >Insert .
6. Go to a later point in your effect giving sufficient time for the clips to
load and cue. For example, press
GoTm , 3 , • , Enter .
7. Select PGM PST Key 1 in the Next Transition area so it will mix on, and
setup a split key with the two DDR channels.