Grass Valley Kayenne K-Frame v.7.0 - Manual (Page 254)

254 KAYENNE K-FRAME — User Manual
Section 7 — Switching Basics
Source Select Buttons and SND
The following describes the Source Select Module organization for source
select buttons (
Figure 141 ):
• Source Selection buttons (left)—Can be mapped and delegated to
buses, macros, routers, etc. and there are no limits to mapping so the
same function or source can be mapped numerous times, and saved in
Panel Memory (Local E-MEM Module/File Ops, Panel Mem menu).
Source selection buttons can be mapped as:
• Switcher sources—Can be delegated to source selection for any
ME bus, Aux bus/Aux selection, Router control, Macros, or E-MEM
recall,
• Shift function—There are four shift levels 1st (unshifted), 2nd, 3rd,
and 4th,
• Row Delegation function—Mapped to the right-most source select
button (default). The SND (Source Name Display) associated with
the row delegation button indicates the name of the bus or function,
e.g. K2, MACRO, Router, U2, etc.,
• SND LEDs— SNDs have two modes, ‘Full’ and ‘Split’. If both adjacent
rows have identical text for a source, it is displayed in full, i.e. large text.
If the two rows have different text, the SND is split into two rows of
smaller text. SNDs show source names, macro names, router source and
router destination names, Aux bus numbers, etc.
• Shift buttons—Shifts can be mapped anywhere on the Source Select
Module (or nowhere) using the
User Prefs , Button Mapping menu (default
is 2nd and 3rd on the second and third source select buttons from the
right).
Function and Delegation Buttons
The following describes the function and delegation buttons ( Figure 141 ):
• Hold button—Sets a bus hold on the delegated row.
• ME bus select buttons— K1-K6 , A , B , U1 , and U2 in columns 2-4, pressing
one of these buttons delegates that bus.
• Macro select button—Delegates rows 1 and 2 of a Source Select Module
to macros.