Grass Valley Kayenne K-Frame v.7.0 - Manual (Page 195)

KAYENNE K-FRAME — User Manual 195
Figure 109. Local Aux Module
To set up a gang for control, perform the following:
1. Press one of the Gang buttons on the Local Aux Module (right). GANG
is displayed in the top row however the button displays are blank. The
bottom row display shows sources mapped to buttons on the Local Aux
Module, in the Panel Prefs, Button Mapping menu. Buttons are colored
white and are low tally.
2. Press the source select buttons of the devices to be ganged. The source
select button for each device will change to green, high tally as they are
pressed.
The gang is dynamic so toggling sources on and off adds/removes them
from/to the gang.
3. Press the Gang button again to exit the Gang mode. The gang remains.
System Bar
Gangs can be controlled using the right-most Device Control Group on the
System Bar. Play, Cue/Load, and Previous and Next commands are all sup-
ported (see System Bar
on page 258 ).
Module
Panel Gangs (Local Aux Bus gangs) can also be controlled with the optional
Device Control Module. Stop, Play, Rew, Fast Fwd, Forward Jog, Reverse
Jog, Mark, etc. are operational in Gang mode (see Device Control Module
on
page 260 ). Panel Gangs and the gang on the ‘ F ’ button (of A-F) are the same
when the SDEL button is selected. Gang device selections made in the
Device Control Module affect gang selections in the Local Aux Bus Module
and vice versa.
Hold Hold
Far ar
Mix
Macro Macro
Rtr
Aux Key Key
Spl
Split
Trans ns
Lock
Hold Hold Macro Macro
Far ar
Mix Wipe ipe Rtr
Aux Key Key
Spl
Split
Trans ns
Lock
Wipe ipe 3Ø
3Ø
AUX2
AUX1 2ND 3RD
ME3 A
Black
ME2 A
Black
ME3 A
Black
ME2 A
Black
ME1 A
Black
Bkgd1
Bkgd2
ME1 A
Black
Bkgd1
Bkgd2
2ND 3RD
35 34 33 32 31 30 29 28 27 26 25 24 23 22 21
28 27 26 25 24 23 22 21
30 29 28 27 26 25 24 23 22 21
28 27 26 25 24 23 22 21
35 34 33 32 31
8623267_21