Grass Valley Kayenne K-Frame v.7.0 - Manual (Page 208)

208 KAYENNE K-FRAME — User Manual
Section 6 — Device Control
3. Press ENT to end the device selection and then learn a cue.
Only the association of the device to the lettered button is learned.
Learning Clips for Devices without Affecting Letter Button Associations
To learn a cue that recalls only device states for the clip, cue to mark, loop,
and play but does not affect the association of the devices with the DCM:
1. Hold down a lettered button, and press the Link Cue button. The letter
button and the button for the device are both high tally.
2. Add devices to be linked into the register, but turn off any lettered
buttons associated with the device.
Without the letter buttons being learned, a recall of the register will
control the specified devices but not affect what is currently happening
on the DCM.
3. Press ENT to end the device selection and learn a cue.
Cues and Gangs
If a device which is learned into a cue is ganged to another device, then that
gang association will be learned into the register too. So that when the reg-
ister is recalled, the devices will be ganged.
Status Display
For a selected device, the display will show ( Figure 116 ):
• Device name,
• Preset or current Page/Bank,
• Last recalled page, bank, and register,
• E-MEM level name,
• Timecode,
• Mark-in/out timecode,
• Calculated duration between mark in and mark out, and
• Clip folder and clip name (folder only displayed if supported by the
device, e.g. ClipStore supports folder display but K2 does not).