Grass Valley Kayenne K-Frame v.7.0 - Manual (Page 194)

194 KAYENNE K-FRAME — User Manual
Section 6 — Device Control
To associate a device with a Device Control Group, hold down a source
select button that has a device attached, then press the PREV and NEXT
buttons together (or you can press and hold down the PREV and NEXT
buttons and then press a source button).
Group buttons:
• Play —Causes the associated device to play (pressing again causes
device to pause).
• Cue/Load —Pressing after a PREV or NEXT button press causes a load
and cue command to be sent to the device, subsequent presses causes a
command to be sent to the device to ‘cue’ to its in-point.
• Next Clip / Previous Clip —Causes the previous or next clip name in the
frame-maintained clip stack list (per device), to be brought into the
Status Display window.
Local Aux Module
Ganging
The Gang Control function in the Local Aux Module allows a single point
of control for multiple devices (
Figure 109 ). The points of control are:
• The right-most Device Control Group on the System Bar, and
• The Device Control Module option.
Note An Aux bus link overrides a set delegate association in the System Bar.
Kayenne systems equipped and configured properly support device
control of Profile DDRs and VTRs. The Gang function permits control of
multiple external devices with the same set of panel controls. Devices can
be ganged so they play together at the same time (original and backup
tapes, for example).
Note The Kayenne Gang function does not synchronize multiple devices and there
is a possibility devices may not respond to a Play or Stop command at pre-
cisely the same time. This may cause a slight offset in playback of multiple
clips.