Grass Valley Kayenne K-Frame v.7.0 - Manual (Page 428)

428 KAYENNE K-FRAME — User Manual
Section 8 — Advanced Operations
Trim Clip operations include:
• Setting only the mark-in point, and touching the Trim Clip button—the
clip will be trimmed from the beginning of the clip to the mark-in point.
• Setting only the mark-out point, and touching the Trim Clip button—the
clip will be trimmed from the mark-out point to the end of the clip.
• Setting both a mark-in and mark-out point, and touching the Trim Clip
button—the clip will be trimmed on both ends (beginning of clip to
mark-in and mark-out to end of clip).
To enter the mark-in/mark out points, either jog, shuttle, or play to the
desired frame and touch the
Mark In/Out button or touch the Mark In/Out data
pad and enter the mark-in/out point in the pop-up keypad, and touch Enter .
Note Trim Clip to mark-in, trims up to the mark point in the clip so the marked
frame is the first frame of the new sub-clip.
CAUTION Trim Clip from the mark-out point, trims (removes) the marked frame and
trims to the end of the clip so the frame at the mark point will not be part of
the new sub-clip.
Make Sub-clips from the Current Clip
A sub-clip can be created from the current clip with mark-in and mark-out
values (or without and the clip length will be the same as the original) or
split into two sub-clips.
1. To enter the mark-in/mark out points, either jog, shuttle, or play to the
desired frame and touch the
Mark In/Out button or touch the Mark In/Out
data pad and enter the mark-in/out point in the pop-up keypad, and
touch
Enter .
2. Touch the Make Subclip(s) button.
3. Enter a clip name or accept the provided name (appends _a) and touch
Enter .
A new sub-clip with the trimmed length is created.
When making a split clip, the first clip is created from the current clip head
to the split mark point, the second from the split point to the clip end.
To split one clip into two sub-clips:
1. Either jog, shuttle, or play to the point in the clip where you want to
split the clip and touch the
Mark Split button ( Figure 263 ), or
2. Touch the Mark Split data pad (below Mark Split button) and enter the
value for the split point in the Mark Split Point pop-up keypad, and
touch
Enter ( Figure 263 ).