Grass Valley Kayenne K-Frame v.7.0 - Manual (Page 359)

KAYENNE K-FRAME — User Manual 359
Copy/Swap
Note Crop Softness controls are not available for crops when Corner Pinning is
enabled in the MFM, however Crop Softness controls are available in the
Menu Panel.
Figure 212. MFM—Crop (Corner Pinning, Crop Menu)
Copy/Swap
Copy and Swap functions are available for MEs, Keyers, and eDPM Chan-
nels. With Copy you can use the settings of one location at a different loca-
tion in the system. This can be useful if, for example, an effect has been set
up on ME 1 but it needs to be placed on-air using ME 2. You can quickly
copy the ME 1 settings to ME 2 and place it on-air, freeing ME 1 for another
purpose. Swap can be useful for multiple users, for example one TD prefers
to use ME 2 for an effect where another TD prefers ME 3. MEs can be
swapped, and swapped back for each preference. When an ME copy or
swap is performed, all the ME settings are transferred. This includes the
current source selections and all keyer settings.
Copy Swap Menus
The Copy Swap menus are used for copying setups from one part of the
system to another. For example, if a chroma key was set up on ME 1, but
the operator needs the key while ME 1 is in use, he can copy the keyer’s
setup to ME 2 and place the chroma key on air there.
The set of menus for Copy and Swap use a common layout. The Copy Swap
Mattes menu, shown in
Figure 213 , typifies the layout shared by the others.
Choose a source in the From pane, choose a destination in the To pane, and
Wipe ipe
1
Key Key
5
Key Key
3
Key Key
1
Wipe ipe
2
Key Key
6
Key Key
4
Key Key
2
PGM
8623267_30
SzLc 3dLc ROT SPIN Axis Adel Last
iDPM ASPT SKEW PRSP 2DLc PGLB All
CROP CPin SHAD FILM FRZ SGLB CLR
Dlg Dlg Dlg Dlg
CR X CR Y CR A
WIPE HOME
CR T
9.000
CR R
16.000
CR L
-16.000
CR B
-9.000
CR A