Grass Valley Kayenne K-Frame v.7.0 - Manual (Page 304)

304 KAYENNE K-FRAME — User Manual
Section 8 — Advanced Operations
2. Select the buses you wish to hold by touching their labeled buttons on
the menu so their green indicators illuminate (
Figure 171 ).
Figure 171. Source Holds Menu
3. Press Lrn on the GV Switcher Control Panel (Master or Local E-MEM
Module), then press a bank and register number to create a new effect
with a Source Hold in its one keyframe.
Source Hold, being a work buffer parameter, will be imposed on other key-
frames as they are inserted, unless turned off in the Source Hold menu. You
may want to start an effect with a Source Hold, so the existing sources will
not change when the effect is recalled, then turn it off to enable source
changes during the running of the remainder of the effect.
Setting a Source Hold in an Existing Effect
1. Locate the cursor on a keyframe in the effect where you wish to add a
Source Hold.
2. Select the buses you wish to hold by touching their labeled buttons on
the Source Holds menu so their green indicators illuminate.
3. Press Modify KF or Insert Before/After to add the Source Hold to the effect.