Grass Valley Kayenne K-Frame v.7.0 - Manual (Page 223)

KAYENNE K-FRAME — User Manual 223
Router Control of Aux Buses
changing that source’s output signal. If an exact match is not found for the
name entered, no change will occur.
Protection
The Router Protection pane (middle) provides protection controls. These
controls are used to send commands to the external router to protect or un-
protect the router destination associated with the selected switcher source.
The button for the current setting of the selected switcher source will be
highlighted. The following protections are available:
• Protection Off – Source can be changed at any time by any control panel,
• Protection Off All Destinations – Same as Protection Off but for all destina-
tions.
• Protection On – Source cannot be changed by another Control Panel, but
may be changed from the GV Switcher system,
• Protection On All Destinations – Same as Protection On but for all destina-
tions.
• On Air Protection – The source cannot be changed by another control panel
when it is on-air, but may be changed manually from the GV Switcher
system. The source will also not be changed by an R-MEM recall, and
• On Air Protection All Destinations – Same as On Air Protection but for all des-
tinations.
External router system panels can place protections on router destinations.
The first panel placing a protection controls that destination. The GV
Switcher system will not be able to change router sources feeding router
destinations protected from another panel, and vice versa.
Router Control of Aux Buses
The GV Switcher can be configured to allow Encore and Prelude control
systems, including standalone Prelude Control Panels, to control Aux bus
source selections.
All switcher Aux buses can be configured to appear on the Router Control
System. Aux buses that are not enabled for router control are seen as being
‘protected’ by the switcher to the Router Control System. In other words,
an Aux bus’ current status (source selection) is displayed but it cannot be
controlled by the Router Control System.
If an Aux bus is enabled for router control, then the source can be changed
by a configured Router Control Panel.
Note Prelude Control Systems are limited to selecting the first 128 switcher
sources.