Grass Valley Kayenne K-Frame v.7.0 - Manual (Page 206)

206 KAYENNE K-FRAME — User Manual
Section 6 — Device Control
Learning a Q-MEM Register with a Single Device
To learn a simple cue with one device (see Figure 114 ):
1. Select a device by pressing a control button, A - F .
2. Select a clip on that device using the bottom soft knob and press the Load
button to load the clip. You can then set the mark-in/mark-out points
(
Mark In / Mark Out buttons) and optionally turn on the Loop button (tallies
blue).
3. Press the LRN button.
a. Optionally, press the Play button (flashes green) to add a play
command (so when the cue register is recalled, the clip will load and
play).
4. Press the desired Cue register number button (use the Page and Bank
buttons for the higher numbered registers). The selected Cue register
button high tallies red.
Learning a Q-MEM Register with Multiple Devices
Learning Devices with Letter Buttons
Lettered button ( A - F) links can be learned as part of a Cue register for later
recall:
1. Press and hold down the letter buttons for the devices to be linked (for
example A, B, and D).
2. Press the Link Cue button (high tallies blue).
3. Learn the Q-MEM register.
4. Press the LRN button.
a. Optionally, press the Play button (flashes green) to add a play
command (so when the cue register is recalled, the clip will load and
play).
5. Press the Cue Register button to recall the cue.
Note To see the link cue status, press the lettered button then the Link Cue button.
Learning Additional Devices
You can link multiple devices in addition to the devices associated with the
lettered buttons using the Cue Device Selection menu (
Figure 115 ). Each
clip will need to be setup with mark-in/out points etc. prior to creating the
link.