Grass Valley Kayenne K-Frame v.7.0 - Manual (Page 285)

KAYENNE K-FRAME — User Manual 285
Aux Bus Transitions
Aux bus transitions use the allocated resources only during the transition.
Any Aux bus can then use the resource as it frees the resource after the tran-
sition.
When resources are allocated, the ME Mode menu still allows for the
keyers to be used on the resource. If keyers are cut on they will only be
visible on the Aux bus during the transition.
To allow both mix and wipe transitions, release the partition of a full ME in
the User Setups, Suite Prefs, Resource Allocation menu. For mix-only, you
can release and allocate a Controller ME resource.
Aux bus transitions can be recalled in a macro but are not E-MEMable,
however the macro can be embedded in an E-MEM.
Performing Aux Bus Transitions
1. Go to the User Setups, Suite Prefs, Resource Allocation menu
(
Figure 160 ).
2. Touch the button(s) of the ME partition you wish to allocate as the
transition resource for the aux bus.
3. Press the Aux Trans button in the Application column.
4. To change the transition rate, press the Aux Transition Rate parameter
button, enter a transition rate in the pop-up keypad, and press Enter .
The Mix and Wipe buttons on the Local Aux Module are now low tally.
5. Select an Aux bus on the Local Aux Module.
6. Press the Mix or Wipe button.
7. Press the Trans Lock button if you wish the mix/wipe transition to
remain selected.
The aux bus is ready for transition to the next source.
Note If you attempt an Aux bus transition while all allocated ME transition
resources are in use, the Aux bus will perform a cut (not a transition). For
example if during a long transition where allocated resources are all in use,
and you switched sources during the transition, the Aux bus would ‘cut’ to
the selected source (it would not mix or wipe).