Grass Valley Kayenne K-Frame v.7.0 - Manual (Page 281)

KAYENNE K-FRAME — User Manual 281
Performing a Mix Through Video Transition
Performing a Mix Through Video Transition
One common application of a Mix Through Video transition is to add a
white flash to simulate a photographer’s flashbulb. To set up a simple
white flash effect do the following:
1. In the ME, Mattes menu, select the ME for the transition (left pane).
2. Select the Base Color data pad (right pane).
3. Set the Brightness to 100% and the Saturation to 0% with either the soft
knobs or the popup keypad to create a white matte. The matte will
appear in the Base Color box.
4. Go to the ME, User Trans menu and select the User Trans Mix Through Matte
(1-6) button.
5. In the ME, User Trans menu, touch the Full Screen button under
‘Intermediate Video Appears’ to create a full raster effect.
6. Change the Initial Mix Ends at to a lower number to sharpen the slope of
the mix from the initial to the intermediate video as shown in
Figure 158 .
Figure 158. Camera Flash Mix Values
7. On the Control Panel, select a video source on the corresponding ME A
bus and a different video source on the B bus to transition to.