Grass Valley Kayenne K-Frame v.7.0 - Manual (Page 284)

284 KAYENNE K-FRAME — User Manual
Section 7 — Switching Basics
turning on the Trans Lock button, the transition will continue to mix or wipe
until it is deselected. With the Trans Lock button off, a mix or wipe will only
transition once and then reset to a cut (cut is the default setting for an aux
bus).
Figure 161. Trans Lock Button—Source Ops, Aux Buses Menu
Setting Wipe Transition Parameters
1. Go to the Wipes menu in the GV Switcher Menu Panel or press the Wipe
button in the Multi-Function Module and set the wipe parameters for
the ME(s) you will use for the aux bus.
2. Select the wipe pattern to be used.
CAUTION When two partitions or more are released for aux bus wipe transitions, it is
very important to make all wipe parameters the same because the dynamic
assignment of ME partitions will not guarantee that an allocated partition will
supply the transition resource for a specific aux bus.
Allocating Resources and Setting up the Transition
Note The DoubleTake option is required for Aux bus transitions.