Delegation pvw bus, Input selection, Setup selector – Grass Valley Kayenne K-Frame v.7.0 User Manual
Page 238: Newton channel information, Newton controls
238
KAYENNE K-FRAME — User Manual
Section 6 — Device Control
Delegation Pvw Bus
The Delegation Pvw Bus pane is used to select which Preview bus will be
used to select the Newton channel to be controlled.
Input Selection
When a video/key source is selected, you choose to control either the video
input or the key input with the
Video
and
Key
buttons.
Setup Selector
The Setup buttons are used to select the desired set of controls from the
setups defined for that channel. The menu displays asterisks for setups that
have no parameters assigned.
Newton Channel Information
Channel
– The number of the GV Switcher input BNC used to select the
current Newton channel is displayed.
Setup Name
– The currently selected setup (1-5) is displayed in this pane.
Additional information for the currently selected channel is displayed
below.
If multiple modules are daisy chained together in a Newton channel, the
information displayed will be for the module with a parameter assigned to
the top knob.
Newton Controls
On the right side of the menu the active control functions are identified.
Direct knob control and datapad numeric entry are available. The menu
displays asterisks for unconfigured controls. The status of the function for
each control is also reported, with green indicating a connection exists and
the data is valid, and red indicating no connection.
Accelerate Knobs
– Selecting this button accelerates knob adjustments by a
factor of 10, providing coarse and fine knob control.
Refer to the separate Newton Instruction Manual for specific information
about Newton controls.