Grass Valley Kayenne K-Frame v.7.0 User Manual
Page 435
KAYENNE K-FRAME — User Manual
435
ClipStore
3.
Determine where you want a mark-in point for the Video track by
either playing/jogging to the mark while viewing the clip on a monitor
and touching the
Mark In
) or if you know the
timecode, touch the
Mark In
data pad and enter the timecode into the
pop-up keypad, and touch
Enter
.
4.
Determine the mark-out point for the Video track and enter it as
described for Mark In.
5.
Turn off the
Use Audio From Video
button (Audio section) by touching it
).
6.
Touch the
Audio
Thumbnail Viewer
.
7.
Touch the
Change Clip
button and touch the desired clip/.WAV file with
the desired Audio track.
8.
Synchronize the Audio track in relation to the current video track
timecode position, if needed, using the
Hold Sync
data pad or the
Audio
Offset
soft knob (see
for more about Hold Sync).
With the
Video Thumbnail Viewer
selected, you can test the composite elements
using the motion control buttons.
Make the Sub-clip
1.
Touch the
Make Clip
button.
2.
Enter the name of the new clip and touch
Enter
.
Add/Replace a Key Element with Build Edit
—In this case, you want to use the
video and audio of the loaded video element but add/replace the key track
and make a sub-clip. The
Use Audio From Video
button is enabled (highlighted
green):
1.
Unless the desired clip is loaded, touch the
Video
thumbnail viewer
).