Figure 268 – Grass Valley Kayenne K-Frame v.7.0 User Manual
Page 436
436
KAYENNE K-FRAME — User Manual
Section 8 — Advanced Operations
Figure 268. Build Edit Mode—Key Track Edit
2.
Touch the
Change Clip
button for the Video and touch the desired clip
(
3.
Determine where you want a mark-in point for the Video track by
either playing/jogging to the mark while viewing the clip on a monitor
and touching the
Mark In
button (
) or if you know the
timecode, touch the
Mark In
data pad and enter the timecode into the
pop-up keypad, and touch
Enter
.
4.
Determine the mark-out point for the Video track and enter it as
described for Mark In.
5.
Synchronize the Key track in relation to the current video track
timecode position, if needed, using the
Hold Sync
data pad or the
Key
Offset
soft knob (see
for more about Hold Sync).
With the Video Thumbnail Viewer selected, you can test the composite ele-
ments using the motion control buttons.
Make the sub-clip
1.
Touch the
Make Clip
button.
2.
Enter the name of the new clip and touch
Enter
.