Grass Valley Kayenne XL Package v.7.0.4 - Manual (Page 96)

94 Kayenne XL Package — User Manual
Section 3 — Control Panel
Delegation to eDPM
When the eDPM is delegated, the upper key row is used to show the eDPM
channels.
On the lower key row the sources for each channel can be selected.
Delegation to Define Memo
When the define memo delegation button is pressed, both key rows will be
delegated to the local EMEM. In this case the source select buttons are used
to select the parts of the switcher whose signals be stored in the EMEM. The
assignment of the buttons corresponds to the EMEM/Define Memo menu
(local EMEM).
Split Key
To create a split key, select a source for the fill signal, hold down the key-
split button, and select a source on a row delegated to the key bus. The
selected source will become the key (cut) selection for that key bus using
the currently selected keyer mode.
• If a bus is temporarily delegated to control a keyer, then the split key
button becomes an on/off toggle, so that again source selection can be
made using two hands.
FAR Button Operation
• When Far is off (inactive), taking a source sets both near and far sides.
• The Far button is active when held down.
• The Far modifier is used for DPM rotation transitions. During DPM
operations the side that is seen by the user is defined as the near-side,
the invisible other side is defined as the far-side.
• To set the far side for the current delegation of a bus, press and hold the
Far button, select a shift level if necessary, and make a source selection
for that side.