Grass Valley Kayenne XL Package v.7.0.4 User Manual
Page 636
634
Kayenne XL Package — User Manual
Section 5 — Stand-Alone Applications
group you could bring down further the number of found commands by
limiting them to only commands which contain e.g. ADDITIVE.
Search via Search Fields
An alternative way to find the desired command is offered via the search
for... fields. button
The moment you start typing in one of the fields the list below offers all seg-
ments matching your entry. You can use one of the found segments to limit
your command search. By using more search for... fields in parallel you can
bring the number of matching commands further down.
In the example above you see that one search for... field contains an "I", the
list below offers all segments starting with "I". The selection of IDPM in this
list, in combination with the selections made via Category, 1st subgroup, and
2nd subgroup limits the matching commands to all commands containing
ME1, KEY3, IDPM. When you are looking e.g. for the command for iDpm
Aspect Ratio you can either walk through the list of found command or use
another search for... field, type "A" or "ASP" to find the ASPECT segment and
select it. Keep in mind that as a result of your search functions the Command
found list can be empty. In this case no single command contains all selected
segments and you have to clear some selections.
When you have selected your desired command you can either enter or
select the according parameter (in the example above 12.5%) or you can
read the current value from the switcher by pressing the update data button.
This function is only available when you are connected to a Kayenne XL
control panel. There are some commands which do not represent a single
parameter state in the switcher like e.g. Recall Emem Register 7 or Reset RGB
correction. For those parameters the update function is disabled.
When the command is completely defined the three insert buttons are
enabled.
•
insert at selected command is only enabled when a command line was
selected before.
If you control more than 1 mainframe in parallel or you want to select a
control panel command you can select another mainframe or the panel as
command destination.
•
The Show Raw Commands checkbox allows you to see the commands in
their native segmented structure.
•
The Show Increment Commands checkbox offers the incremental in place
of the absolute command if applicable