Grass Valley Kayenne XL Package v.7.0.4 - Manual (Page 638)

636 Kayenne XL Package — User Manual
Section 5 — Stand-Alone Applications
Create New Multiple Commands 'Kayenne XL' Style
Figure 527. Stand-Alone Macro Editor - Create Multiple Commands
Snapshots are used to recall a large group of parameters; macros are used
to recall individual parameters. This was the case until now and it still
makes sense in most situations.
One reason snapshots were preferred above macros for multiple parame-
ters was the fact, that macros had to be built command by command,
including the selection of the parameter. This becomes rather time con-
suming for a larger amount of commands.
This dialog allows you to insert a complete group of commands with only
a few button presses. Just click e.g. the Transi button in the ME2 group and
all command handling the transition module of ME2 are listed. To update
the parameters press the update parameters button. When all parameters are
updated you can insert them via one of the three insert buttons. The insert
at selected button is only enabled when a command line was selected
before.
All actions (insert, update parameter, and remove) are applied to all com-
mands in the list as long as no command is selected. When you select one
or more commands (standard Windows selection mode with Control and
Shift button), only the selected commands are affected.
This dialog is only available when you are connected to a Kayenne XL
control panel.