Grass Valley Kayenne XL Package v.7.0.4 User Manual
Page 380
378
Kayenne XL Package — User Manual
Section 4 — Sidepanel Menu Summaries
Transition Trigger
Transition Trigger Preset/Program Bus is used in combination with the
Input Event functionality and can be configured in the Ebox/Install/Input
Menu (Menu number 040102)
With Input Event you can assign an Event to each of the physical inputs. An
Event can be an auto start of a Tape Machine, Video Server, a complex time
lime, snap shot or DVE Effect.
If you use an auto start of Video Server, the Kayenne XL can be configured
in a way where you just need to push the source button assigned to the
input which is used for the Video Server.
The Cut/Auto button or even the Transition Bar can be used to start the Video
Server and switch the source to the program output. The following
example explains how to configure an auto start of a Video Server config-
ured as Media Player 1 connected to video input 1, using the PP stage.
Example:
Auto Start of a Video Server using the Cut/Auto button or Transition Bar:
1.
Make sure that the used video server is connected through a serial cable
connection to the mainframe, the connection is established, and the
clips are also available and navigable using the Media Player (130100).
The configuration of the Video Server can be done in the
Installation/Ebox/Machine menu (040110). For detailed information, refer
to
.
2.
Open the Install/Machine menu (040102). Double click on the Event tab
which is corresponding to the input. In this case input 1. Now you will
see the main group page of the event menu. Use the following path to
assign the play command for the video server to the corresponding
Video Input:
Machine Control/Media Player 1/Motion Command/set by value/Play
3.
Now open the Config/Ebox/M/E/Misc menu (050108). Switch Cut Trigger
PGM Bus to on in order to enable the event assigned to the input 1. Next
make sure that Input 1 is not selected at the Program Bus, and load an
existing clip from the server, using the Media Player Clips menu (130100).