Grass Valley Kayenne XL Package v.7.0.4 - Manual (Page 497)

Kayenne XL Package — User Manual 495
Media Player Menu
• Loop: Enable or disable Loop Mode for AMP controlled devices.
Note On serially controlled machines (using the AMP protocol), the current IN and
OUT marks are ignored for the loop. In other words, a clip is always played
from SOM (start of material) to EOM (end of material) or vice versa. This also
applies to LAN controlled machines when the "Mark Control" feature is dis-
abled. If "Mark Control" is enabled (see "MCtl" section for details), the IN and
OUT marks are taken into account for the loop.
• Mark Control: This feature is only available for machines which are con-
trolled over LAN.

When Mark Control is enabled, the IN and OUT marks stored within
the metadata of a clip are controlled directly. In other words, metadata
of a clip can be changed. In combination with the loop mode, a clip can
be played in loop between its IN and OUT marks. This kind of loop is
completely controlled by the external machine and therefore 'absolute
accurate'.
For more Details about IN/OUT Mark Handling see section Some More
Details About IN/OUT Mark Handling on page 163 (Device Control Module).
Refer also the Media Players (MPs) section of the Multi Function Control
Panel.