Grass Valley Kayenne XL Package v.7.0.4 - Manual (Page 179)

Kayenne XL Package — User Manual 177
System Bars
Macro Attachment
• Attach Enable: 
Pressing this button turns the macro attachments ON and OFF macro
attachments. When OFF, all attached macros are disabled, and the
buttons revert to their original functionality.
• Show Attach: 
An ON/OFF toggle. When ON, all buttons which have a macro
attached flash.
• Replace Attach: To replace-attach pre-defined macros to a button:
1. Delegate the required bus rows to macros as needed.
2. Press the Replace Attach button. The Attach button tallies high.
3. Hold down a macro button.
4. Hold the button to which the macro is to be attached.
When the replace-attachment is done, the ReplaceAttach button tallies low.
To attach further macros, repeat steps 2 to 4.
To pre-attach a macro:
1. Delegate the required bus rows to macros as needed.
2. Hold down a macro button.
3. Hold the button to which the macro is to be attached for two seconds.
4. To check if the macro is attached, press Show Attach.
To post-attach a macro:
1. Delegate the required bus rows to macros as needed.
2. Hold down the button to which the macro is to be attached.
3. Hold the macro button for two seconds.
4. To check if the macro is attached, press Show Attach.
To delete a pre-attached macro:
1. Hold down the Delete button in the macro editing section.