Grass Valley Kayenne XL Package v.7.0.4 - Manual (Page 183)

Kayenne XL Package — User Manual 181
System Bars
Operational Example:
• Attach all RamRecorder channels to the related RamRecorder output
sources
• Assign all RamRecorder channels to one machine control group in the
Systembar
• Associate the desired ME bus (e.g. ME2 PGM) to the RamRecorder
output sources
From now on a RamRecorder channel can immediately be controlled on the
machine control group right after the related output source is selected on
ME2 PGM.
Prev/Next
• When there are clips on the assigned machine available, the Prev and
Next buttons are used to navigate through the list of clips.
• The clips are pre-selected (not loaded).
• When a RamRecorder channel is assigned to the machine control
group, pressing Prev and Next simultaneously changes to still selection
mode. In that mode the buttons are used to preselect RamRecorder
stills.
• When a machine that is controlled via LAN is assigned to the machine
control group, pressing Prev and Next simultaneously changes to folder
selection mode. In that mode the buttons are used to navigate between
the available folders on the external disk server. Pressing Prev and Next
again changes back to clip selection mode.
Cue/Load
• Pressing this button after a clip/still/effect/folder has been pre-
selected by Prev or Next causes a load command to be sent to the
device.
Note In folder selection mode, the selected folder will become the current working
folder. After switching back to clip selection mode, the machine control group
will then show the clips of the new working folder.
• The button is high-tally when the selected clip/still/effect is loaded
resp. when the selected folder is the current working folder.