Grass Valley Kayenne XL Package v.7.0.4 - Manual (Page 129)

Kayenne XL Package — User Manual 127
Local EMEM
Selecting a Register While Storing
During the storing of snapshots or timelines the register to be used for
storage must be selected. The procedure is the same for both cases.
However, the indication in the display differs:
• STOR - for Snapshots
• EDIT - for Timelines
If the register number is to be taken over that was shown before the actua-
tion of the Store or Edit button, no further selection is necessary.
During storing, the contents of the register is overwritten.
If you wish to select the next free register, press the FREE button.
If you wish to select a particular register, enter a one- or two-digit number
with the numeric keypad. Errors can be deleted with Clear.
Note Should the register be assigned, the contents is overwritten when storing.
Selecting a Register While Recalling
When a snapshot or a timeline is recalled, there are several ways to select a
corresponding register.
If the register shown in the display is to be used, no further selection is nec-
essary.
To select the next used register, press the NEXT button.To select a particular
register, enter a one- or two-digit number with the numeric keypad. If a
two-digit number is entered (for eyample, 15), the related register (1)
appears in the display when the first digit (1) has been entered. The desired
register (15) appears after the input of the second digit.
The input of the figures need not be confirmed with Enter.
Storing a Snapshot
1. Set the switcher in the desired operation mode.
2. Set Define memo.
3. Press Store.
4. Select register with numeric key pad.
5. Press Enter.