Grass Valley Kayenne XL Package v.7.0.4 - Manual (Page 110)

108 Kayenne XL Package — User Manual
Section 3 — Control Panel
ified by the operator. The new key priority stack is defined using the Keyers
subpanel or via a menu.
Transition Types
The DPM , Mix , and Wipe transition type buttons select what type of transi-
tion will be used on the elements selected above for the next transition.
Pressing these buttons does not change the appearance of the current
output of the switcher. Only one transition type can be selected at a time.
• The DPM button is only available for Key Transitions. If the Background
is selected for next transition in combination with keyers, the back-
ground will perform an add/mix/wipe transition, depending on the
last transition type selected prior to the DPM selection. This type will
be indicated in the display above the BGD button.
The behavior of a DPM Key Transition is as follows:
In a mix/wipe transition the Lever Arm or the Auto Trans control the video
amount of the keyer. In a DPM transition the Lever Arm or the Auto Trans con-
trols the timeline of the DPM effect selected for this keyer.
When the key was off at transition start, the video amount of the keyer is
fully switched on at transition start, allowing to fly the key in.
When the key was on at transition start, the video amount of the keyer is
fully switched off at the end of the transition, allowing to fly the key out.
Note The DPM effects used for transitions should be built in a way that the last key-
frame is out of screen or size zero.
• The Mix button selects a mix as the next transition.
• The Wipe button selects a wipe as the next transition. Each wipe is pre-
defined using either the complex wipe generators or the Utility buses
as the wipe shape. Wipe pattern selections are made in the Wipe menu.