Altera CPRI IP Core User Manual
Page 191

Appendix E: Delay Measurement and Calibration
E–13
Single-Hop Delay Measurement
December 2013
Altera Corporation
CPRI MegaCore Function
User Guide
shows the Tx path delay components in all CPRI IP core variations except
those that target an Arria V GT device and are configured with the CPRI line rate of
9.8 Gbps. This figure shows the relation between the two Tx paths.
In the CPRI IP core the delay from the AUX interface has a fixed component and a
variable component. In the variations that do not target an Arria V GT device or that
are configured with a CPRI line rate other than 9.8 Gbps, the variable component
results from the Tx elastic buffer and the Tx bitslip delay compensation feature.
The Tx path delay from the AUX interface in most CPRI IP core variations comprises
the following delays:
1. Fixed delay from the AUX interface through the CPRI low-level transmitter to the
Tx elastic buffer. This delay depends on the device family and CPRI data rate. This
delay is the first component of
T_T4
in
Figure E–1 on page E–2
and in
. Refer to
“Fixed Tx Core Delay Component” on page E–14
.
2. Variable delay through the Tx elastic buffer, as well as the phase difference
between the core clock and the transceiver
tx_clkout
clock. The
section shows how to calculate the delay in the CPRI Tx
elastic buffer, which includes the phase difference delay.
3. Variable Tx bitslip delay in CPRI RE slaves. Refer to
4. Fixed delay from the Tx elastic buffer to the transceiver. This delay depends on the
device family and CPRI line rate. This delay is the second component of
T_T4
in
Figure E–1 on page E–2
and in
. Refer to
.
5. Link delay through the transceiver. This delay is
T_txv_TX
in
Table E–7 on
page E–16
.
Figure E–5. Tx Path Delay from AUX Interface or Through MAP Interface Block to CPRI Link in Most Variations
AxC IF 0
AxC IF n
...
AUX Interface
Data Channels
Transmitter
Transceiver
Transmitter
tx_dataout
Physical Layer
CPRI MAP
Interface Module
AUX
Module
(1)
(1)
(5)
(4) (3) (2)